First Layer Issues - Troubleshooting - V1 Engineering Forum
4.6 (480) In stock
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
First Layer Issues - Troubleshooting - V1 Engineering Forum
prusa i3 - First layer looks weird and print fails - 3D Printing
First Layer Frustrations – Assembly and first prints
3D Printing Layer Issues - Advice - V1 Engineering Forum
First Print - Troubleshooting - V1 Engineering Forum
I am having trouble with my first layer : r/AnkerMake
First Print - Troubleshooting - V1 Engineering Forum
First layer issues – Assembly and first prints troubleshooting
First Layer Problems – Assembly and first prints troubleshooting
3D print improvements - Troubleshooting - V1 Engineering Forum
First Layer Problems – Assembly and first prints troubleshooting
Well, I'm getting started! - Troubleshooting - V1 Engineering Forum
First layer problem with PETG - Irregular results – Assembly and
Cura First Layer Settings: Initial Layer Simply Explained
First layer not good on Bambulap P1P - Bambu Lab P1 Series - Bambu Lab Community Forum
First Layer Problems : r/BambuLab
Laying down the first layer with: a) 100% flow, b) increased flow